Little-Known Anvil Makers

By Clayton Ray

Postman’s 1998 book, Anvils in America, is a landmark in the study of American anvils. He documented all of the major makers and many minor ones. It would, however, be too much to expect that he could have exhausted the subject, but not too much to suspect that some among the varied membership of EAIA might have knowledge of obscure brands, from advertising, brochures, catalogs, or other scattered contemporary sources. A few examples may serve to clarify the subject. All are late nineteenth or early twentieth century cast anvils.

Postman, page 140, recorded one “GEM” anvil but found no information on the maker. It is a cast iron anvil, unusual for its lugs for anchoring it, otherwise known almost exclusively on Fisher anvils.  My example is shown below.

Detail of “GEM” anvil with scale

Postman, pages 197-203, documented the American Star anvil, made in Trenton, NJ, the outstanding feature of which is its patented so-called “tempering cavity,” a cylindrical hole extending from the bottom well into the core of the anvil. The logo is a 5-pointed star centered on its right side.

Star was a popular logo and name of a wide variety of manufactured products, including one or more little-known anvils in addition to the American Star. Among these is the Swedish North Star brand, with a 5-pointed star. I have two anvils of about 100 lbs. each with embossed stars, about 2.5 inches in diameter, on the right side. These stars are unusual in being 6-pointed instead of the common 5-pointed stars. The only other mark is the weight on the front foot.

6-pointed star anvil. Although not very clear, the top scale on the ruler is in inches.

 

I have two anvils, one 8 lbs. and one 58 lbs., marked “U.S.A.” in large embossed letters on the right side. The letters are set in a recessed rectangle with rounded corners. They have hardy holes, but no pritchel holes.

Overall view of the anvil marked “U.S.A.”. Again. the top scale on the ruler is in inches.

 

Detail of the “U.S.A.” cast in the anvil.

 

Last, and to me most interesting, is an 18-lb. bench anvil, with no name, but with “chilled semi steel” in embossed letters along the right side near the bottom. Most unusual are swales on the underside, four linear crosswise and four circular, one at each corner.

 

 

18 lb. anvil with “CHILLED SEMI-STEEL” embossed on foot.

 

Detail of 18-lb anvil with embossed “CHILLED SEMI-STEEL” and swales evident on the underside.

Your help is needed in filling out information on these and many other obscure makers of U.S. anvils.

Clayton Ray

One Comment on “Little-Known Anvil Makers

  1. Trying to find out about an anvil I picked up this weekend.
    It’s a WMI 263 that was built in 1949.
    It has both the Hardy hole and Pritchett hole.
    It has an emblem on it but can not describe it.

Leave a Reply

Your email address will not be published. Required fields are marked *